Since the bead mill also makes extensive use of machine maintenance become a regular job, long life relatively higher quality of sanding machine, but if maintenance work is not well maintenance the life of the machine and operating efficiency have a direct impact. To avoid machine will be abnormal in the work process, to ensure the normal operation of the machine, in addition to the requirements of routine maintenance, but also regular stop grinding, hollow shaft, main bearings, cylinder and gear reducer and the size and other important part do careful examination. Then the development of relevant repair plan. Here and tell you about the daily inspection from what.
Sander all lubricants in a bead mill can only operate one month would release all of the machine and lubricating be thoroughly cleaned and get new replacement once the new oil. You can also change the oil after once needed six months. Height lubrication and oil lubrication points each should regularly check at least once every two hours to check. Mill in operation, the main bearing lubricating oil temperature to exceed 58 ℃. The temperature transmission bearings and gear unit can not be higher than 58 ℃, the maximum does not exceed 70 ℃. Large and drive pinion to be very smooth, and no abnormal noise. Also timely adjust the gap. Sanding machine in operation is very smooth, it does not have a strong vibration. Motor current will not produce abnormal fluctuations. Each connecting the outer to not loose fasteners, bonding surface outside no oil spills, leaks and no Loumo phenomenon. To promptly added ball easy to wear. If found to have abnormal immediately stop grinding inspection and maintenance. To replace timely mill liner wear rate was 80% or have 90mm long cracks. That is also produced to replace the main bearing serious frayed. When the lattice type of machine Grate plates are subject to wear, if not then welding should be replaced immediately. If the large gear side by a certain need not hurry to replace worn, it can continue to be used upside down. All wear parts can not be used as long as there will be updated in order to continue to use. These are the aspects on machine inspection and maintenance needs attention.